Labconco Cell Logic A2 User Manual page 15

Air-Tight Damper
AIRFLOW
ADJUSTMENT
HANDLE
Visual appearance of biosafety cabinet and exhaust connection may vary by model.
User-Supplied Microscope Requirements – Scope-Ready™ Package Only
If installing a microscope, locate the Stand-Still™ Isolation Platform in a separate box
shipped with the cabinet. The Stand-Still Isolation Platform supports the microscope on
top of the stainless steel work surface to eliminate up to 94% of vibrations and to
promote safe airflow. If using a stereoscope with a forward extending base, the
extended Stand-Still XL Isolation Platform should be ordered from
Accessories. Figures from
On models with the Scope-Ready package, the Cell Logic Biosafety Cabinet includes a
clear, disposable Pure-Vu™ Seal that can be altered to accommodate most
microscope's eyepieces. Utilize the Punch Kit (Catalog Number 4027801), supplied with
your cabinet, to cut the two eyepiece holes at approximately 2.75" (69.9 mm) spacing to
match the height of your scope. As a convenience, pre-cut Pure-Vu eyepiece seals can
be ordered from Section 9:
based off the nominal height from the base of the microscope to eyepiece centerline
and can save time modifying the seal shipped with the Cell Logic. If using a stereoscope
with a forward extending base, one of the Pure-Vu XL Seals should be ordered from
Section 9: Accessories. Figures from
for all Pure-Vu Seals.
Appendix E should be used to assist your set-up.
Accessories. The pre-cut accessory Pure-Vu Seals are
Appendix E
15
Figure 2-6
BUILDING EXHAUST DUCT
(NOT INCLUDED)
DUCT COLLAR
AIR-TIGHT DAMPER
BIOSAFETY CABINET
DUCT STUB
Section 9:
should be used to assist your set-up