Labconco Cell Logic A2 User Manual page 28

Electrical Connection
The product's power cord is located in the Parts Box removed in the final step of
Unpacking (previous section). Connect the IEC end of the power cord to the IEC
connector located on the rear side of the top electrical box. See Figure 4-4. Connect the
plug end of the power cord into an appropriately rated outlet (see Electrical
Requirements in Section 2: Before You Install).
Figure 4-4
Knockout
IEC Connector
A knockout is also provided in the electrical box to allow for direct wiring of the product.
Do NOT attempt to connect power via the knockout or otherwise directly wire the
product without consulting your local codes and regulations, and it is highly
recommended to utilize a licensed electrician to make this wiring connection. The wiring
must meet the minimum gauge requirement for the current specified in Section 2:
Before You Install listed under Electrical Requirements, and must be a dedicated wiring
run to a circuit breaker appropriately rated for this product's electrical requirements.
28