Labconco Cell Logic A2 User Manual page 70

TM
Vacu-Pass Cord & Cable Portal (optional)
The Vacu-Pass allows for passage of a cord, cable, or tube from within the product. The
pass-through provides a sealed plug, and the plug housing is maintained under
negative pressure to safely pass cords through the right side wall of the product. Not all
models are configured with Vacu-Pass ports, if your model does not contain this option,
this section may be skipped.
Some Vacu-Pass components and the cord passing through it may become
contaminated during use of the cabinet. Ensure all potentially contaminated
components are surface decontaminated before handling or removal from the cabinet.
1. Remove the grommet from the liner side wall. Remove the pre-cut plug from the
body of the portal by either pressing it through from the outside, or by carefully
inserting a spatula or similar device between the sealing plug and the body of the
portal, and prying the plug out.
2. If running the cord or cable through the portal on the side panel, remove the portal
cap. If needed, carefully insert a spatula or similar device under the perimeter of
the portal cap to pry it out. Pass the cord or cable through the side panel portal to
the pre-cut plug.
3. If running the cord or cable up or down under the side panel, leave the portal cap
installed. Pass the cord or cable behind the paneling as needed to the pre-cut plug.
4. Pass the cord or cable through one of the pre-cut plug holes, then through the
grommet, as shown in Figure 7-4.
Note: Select a pre-cut plug hole that is slightly smaller than the cord or cable, to create
a proper seal. The pre-cut plug has a core piece that must be removed before inserting
the cord.
Side-Panel
Portal
Portal Cap
5. Position the cord or cable as it will be used in the cabinet, and then push the plug
back into the body of the portal until it seats in the portal. Reinstall the grommet.
Pre-Cut Plug
Grommet
70
Figure 7-4
Cord or
Cable
Portal