Loading Paper - Printronix L7032 User Manual

3.4 Loading Paper

Follow these instructions to load continuous fanfold paper in the printer.
1. Release the two slender green tractor locks
printer. See Figure 3-1.
When the locks are released, you can move the paper tractors back and forth easily. Note
that both locks must be released for either tractor to move.
Figure 3-1. Paper Tractors, Paper Sensor, and Top-of-Form Sensor
2. Open each of the two tractor covers by grasping the inner edge of the cover and raising it all
the way up.
3. Place the paper evenly on the paper tractors so that the lower rows of tractor pins fit through
the holes in the paper. The paper must cover the black paper sensor. The paper must not
extend over the top-of-form sensor. Figure 3-1 shows the paper sensor and top-of-form
sensor.
Caution: If you put paper over the top-of-form sensor, the printer will not be able to start
the printed image at the correct position on the paper.
4. Close the tractor covers.
5. Adjust the width of the tractors so the paper is moderately tight between them.
46
by rotating them toward the inside of the