Cleaning Supplies; Weekly Cleaning Procedure - Printronix L7032 User Manual

5.4 Cleaning Supplies

Most of the supplies you need for cleaning and maintenance come with the printer and its
consumables. In addition to these cleaning supplies, a particle vacuum is recommended.
5.4.1 Wire Cleaning Brush
The wire cleaning brush comes w
door. The brush fits into slots on the main charger unit and the transfer charger unit so that you
can clean the fragile corona wires without breaking them.
Each OPC module kit includes a wire cleaning brush.
5.4.2 Cleaning Kit
A cleaning kit comes with the printer, and each developer kit includes a replacement cleaning kit.
The cleaning kit contains:
•
Soft brush
•
Several cleaning swabs
•
Several moist cleaning cloths
If you need a new cleaning kit before you need to replace the developer unit, you can order one.
See Chapter 7 for ordering information.

5.5 Weekly Cleaning Procedure

Follow these instructions on a weekly basis or whenever the printer prints 30,000 11-inch pages.
5.5.1 Clean the Main Charger Unit
1. Make sure all your print jobs are finished. Then stop the printer and take it off-line.
2. Use the on/off switch on the paper-input side of the printer to turn the printer off.
Caution: Do not turn the printer off, unplug the power cord, or open the front access door
while the printer is printing. If you do, the paper will jam, and you will lose the
data that has been sent to the printer.
3. Remove the paper from the printer.
4. Open the front access door on the front of the printer.
5. Grasp the main charger unit by its black handle and pull it straight out of the OPC module.
See Figure 5-1.
Caution: The grid on the bottom of the main charger unit is fragile. Be careful not to
damage it.
78
ith the printer and is stored insid e the printer's front access