Printronix L7032 User Manual page 79

Figure 4-26. Retu
5 . Return the back-up exit roll
the rollers nearest the front of the printer.
6. Plug the fuser unit's two electrical connectors into the printer. Plug in the larger connector
and then plug in the smaller connector. Both of them will click into place.
7. Turn the fuser latch counterclockwise slightly and hold it while you start to push the fuser
drawer back into the printer. Once the fuser drawer starts to go into the printer, you can
release the fuser latch. Push the fuser drawer into the printer un
8. Close the printer's front access door.
9. Use the on/off switch to turn the printer on.
1 0. Put the printer on-line
11. Dispose of the spent fuser unit and the spent exit rollers in the trash.
1 2. Record the replacement of the fuser unit an
rning the Exit Roller Paper Guide to Its Operating Position
ers to their original position using the black handle on the side of
and make it ready.
d the exit rollers in the maintenance & service log.
til it latches.
75