2.1.3 Status Display
The operator panel has a two-line liquid crystal display (LCD). Each status line can show up to 16
characters.
2.2 Printer Operation Menus
T
he printer's functions are controlled by c
the operator panel. When you set the printer up, you can use the operator panel to select vario
parameters for the particular job at hand. These parameters can be saved and re-used later as
individual "pre-saved" configurations.
This section summarizes the printer operations menus. By pressing combinations o
arrow buttons (◄►▲▼) and the SHIFT button when necessary, you can navigate through thes
menus and set various printer parameters.
To
en r the menu syst
te
CO
NF
IG
URATIONS displaye
can
sc oll to the main menu selectio
r
•
Configurations
•
Consumables
•
Form Configuration
•
Print Engine Configurati
•
Page Menu (if only the
installed, t
his men
which emulation is active)
•
Interface Configuration
•
Operations Menu
•
Test Print
•
Active
Emulation (this menu only appears if IGP software is installed in the printer)
Press ▼ button to select the desired menu. Follow the chart below to navigate the menu
s
tructure.
S/ means press the Shift button and another button simultaneously. S/▼ = Shift plus Enter,
S/▲ = Shift plus Exit, S/◄ = Shift plus Form Feed, S/► = Shift plus Back Feed.
16
ompleting menu selections by pressing the buttons on
em, press the MENU button. You will see MAIN MENU with
d below it. By pressing the left and right arrow buttons (◄►), you
ns. These are:
on
PCL
emulation is installed. If the PGL or VGL emulation option is
u displays "PCL Setup", "PGL Setup", or "VGL Setup", depending on
us
f the four
e