Printronix L7032 User Manual page 164

Disable. The position of the next graphic element will be determined as if the font was
monospaced (all characters had the same specified width).
Repeat Form
Whe n enabled, this m
form s where th e entire form is enclosed in the ^IREPV...^IREPE command.
Enable (th e default). Speeds up the processing of repeated forms for PGL, thereby resulting in
increased printer throughput. This option provides no speed benefit for forms that are
unrelated to one another and should be disabled under those circumstances.
Disable. Should be selected when subsequent forms are unrelated to on
Rot . Char Size
Adjusted. Rotated (clockwise/counterclockwise), expanded characters have a different size
than an unrotated chara
Not Adjusted. Rotated, expand
with the sam e size parameters.
The factory default is Adjus
Sel ect CPI
Thi s item selects the characters per inch (CPI) value.
The options are 10.0, 12.0, 13.3, 15.0, 17.6, and
The factory default is 10.0 CPI.
Select LPI
Thi s is the number of lines to be printed per inch. For example, at 6 lpi there is
1/6 inch from th e top of one print line to the top of the next print line.
The options are 6 - 10 LPI.
The factory default is 6 LPI.
Select SO Char
Allows you to specify a decimal code from 0 through 255 to be used in place of SO (Shift Out) as
the control code which allows access for the alternate set of control function characters. See the
des cription of the Code 128 barcodes in the VGL Programmer's Reference Manual for details.
The range is 0-255, and the factory default is 14.
Sel ect SFCC
Thi s option selects the Special Function Control Code. The default value
94). Valid values are 17 through 255. Run a configuration printout to determine the currently
selected SFCC.
The range is 1 7-255, and the factory default is 94.
Sla sh 0
This paramete r allow
to all character sets except OCR A and OCR B.
Disable (the default). Zero is printed without a slash.
Enable. Zero is printed with a slash.
160
enu speeds up the label printing for repeated form. This only applies to
cter with the same size parameters.
ed characters will be the same size as unrotated characters
ted.
s you to print the numeral "0" with or without the slash. This option applies
20.0 CPI.
e another.
is the caret ^ (decimal