Printronix L7032 User Manual page 115

6.2.4 Image Is Too Light
1. Make sure that all consumables are installed in the printer.
2. Make sure that all consumables are within their expected lifespan by checking the
information in the maintenance & service log. Replace any consumable that has been in use
longer than its expected lifespan. Follow the instructions in Chapter 4, Replacing
Consumables.
3. If you just installed a new toner cartridge, make sure that the plastic seal has been removed
from the toner cartridge.
4. If the operator panel is displaying a "Toner empty" message,
c artridge is not empty.
5. Clean the printer. Follow the instruction
Cleaning Procedure.
6. Are you printing with Economy Mode on, with Print Density set to Lighter Image, or w
both? If you are, turn off Economy Mode, set Print Dens
A cross -ref erence to OEM data controller information that explains how to set Economy Mode
and Print D ensity goes here.
7. Make sure the developer unit is installed correctly. Remove it fro
Follow the instructions in:
•
Section 5. 6.1 Prepare to Remove the Consumables
and
•
Section 5.6.3 Remove the Developer Unit
8. W hile you have the developer unit out of the printer, check the electrical connectors between
the developer unit and the printer. See Figure 6-1 and Figure 6-2 in Section 6.2.2 No Image –
No Toner on Paper (White Page).
If the electrical connectors are damaged, call a service technician.
9. Check the gear coupling between the developer unit and the main drive assembly:
•
Check the developer unit's gear. See Figure 6-1 in Section 6.2.2 No Image – No Toner on
Paper (White Page).
•
Look inside the printer and check the gear that drives the gear on the developer unit. See
Figure 6-2.
If the gear on the main drive assembly or the gear on the developer unit is damaged, call a
service technician.
10. If the electrical connectors and gears do not appear to be damaged, reinstall the developer
unit in the printer.
Follow the instructions in:
•
Section 5.6.11 Install the Developer Unit
and
•
Section 5.6.13 Finish the Procedure
make sure that the toner
s in 5.5 Weekly Cleaning Procedure and 5.6 Monthly
ity to its default, or both.
m the printer.
ith
111