Printronix L7032 User Manual page 149

Host Form Length (PGL)
Determines how the physical label length (see Label Length under the MEDIA CO
affected upon receiving an EXECUTE command.
Enable. The physical label
command). The physical la
command is received, or th
Disable. Fo rms printed in EXECUTE mode do not change the physical label size. Therefore,
the size of the form (defined in CREATE mode) must fit within the current label dimensions,
or errors may occur.
Changing the form length via the EXECUTE command ch
dimensions.
The factory defau lt is Disable.
I-2/5 Selection
This option is added to be compatible with a special IGP-X00 customization. Usually, if nterle
2/5 bar codes have an odd number of digits, a lead
However, this special IGP-X00 customization gives
the end of the bar c ode instead.
Leading Zero. A leading zero is inserted in front of the data.
Trailing Space. A space is insert
X2 DPD. When selected, I-2/5 bar code with a magnification X2 will use th
configured ratios 3:3:6:5 rather than 3:6:9:12 for compatibility i
Modu lo 7 CD. The I-2/5 bar code uses a modulo 7 check digit instead of the default modulo
10 ch eck digit.
The factory default is Leading Zero.
Ign ore Mode
Thi s parameter instructs the IGP to ignor
m enu.
Disable. The IG P does not ignore any characters.
Enable. The IGP ignores the character specified in the Select Character men
The factory default is Disable.
Ignore Text
Disable. When disabled, text in normal mode will be printed.
Enable. When enabled, any line of text (non-PGL commands) in normal mode will be ignored.
The factory default is Disable.
IGP100 Compatibl.
Thi s parameter forces the output to correspond with IGP-100 printer output in cases where t
are d ifferences.
The options are Disable (the fa
Lead PDF Dist
Adjusts the leading and trailing character spacing distance of the PDF for UPC/EAN barcodes.
The range is 0.01- 0.10 inches in 0.01 inch increments, and the factory default is 0.10 inches.
length will change to match the form length (specified in CREATE
bel size remains at the new setting until another EXECUTE
e PRINTER CONTROL menu settings are changed.
ing zero is inserted in front of the data.
you the option of adding a space character at
ed at the end of the data instead of a leading zero.
e the character selected under the Select Character
ctory default) and Enable.
NTROL menu) is
anges the LP+ Emulation logical
e specially
ssues.
u.
aved
here
145