Printronix L7032 User Manual page 154

Trunc D yn Data
Thi s submenu allows the user to truncate the dynamic data up to the maximum data length
spe cified in Create Mode.
Disable (the default). If the
report.
Enable. If th e dynamic data exceeds the maximum data length, the data truncates.
UPC Descenders
This paramete r allows you to print bar code descenders when
pre sented in the UPC/EAN bar codes.
Always (the default). UPC/EAN bar codes are printed with descenders, ev
human readable data.
Never. UPC/EA N bar codes are printed without descenders if the PDF command is present.
Only With PDF. UPC/EAN bar codes are printed with descenders only when the PDF
command is presented.
User-Def Ratio
This option allows you to ignore the user-defined barcode ratio and replace it with the default
ratio (X1).
Enable (the default). Allows the user-defined barcode ratio.
Disable. The user-defined barcode ratio will be replaced with the default ratio (X1).
Var Form Adjust
This specifies an amount (in tenths of inches) to add to the length of variable-length forms.
Variable-length forms use a semicolon at the end of the CREATE command:
~CREATE;<FORMNAME>;0.
Typically, variable-length forms are determined by the elements within the form. The longest form
element becomes the overall form length. This option allows an additional space to be added to
the form length.
The range is 00.0 to 03.0 inches, and the factory default is 00.0 inches.
Var Form Type
Add Nothing (the default). When selected, no action is taken.
Add ;0. When selected, the form length ends at the longest printed element. (Same as
~
CREATE;filename;0)
Add ;X. When selected, the form length is the same as the physical page length (the Label
Length menu under MEDIA CONTROL). (Same as
Vertical Adjust
This option is to adjust printer dpi to expand or shrink the vertical position of graphic elements
and the height of the vertical line. The default is 0 dots. The adjustment range is from -10 dots to
20 dots with respect to the current printer dpi.
150
dynamic data exceeds the maximum data length, an error will
human readable data is not
~
CREATE;filename;X)
en if there is no