Printronix L7032 User Manual page 42

21. Press the ▼ arrow. The display will show:
"TEST PRINT MENU / Configuration"
22. Press SHIFT + ▼ simultaneously to select the current printer configuration. The display will
quickly show:
"Configuration / Working..."
Then:
"Configuration / Ready to Print"
Then:
"TEST PRINT MENU / Configuration"
23. Press the READY / STOP button twice to print the configuration:
"Processing"
Then:
"Printing"
24. Verify that the network parameters are assigned correctly to the printer NIC (network
interface card) – shown on the configuration printout items under "Network Config." To verify
connectivity, at the DOS prompt type ping <IP Address>. Save the configuration printout
with the printer documentation.
2.3.2 Selecting the Ethernet Interface Manually
1. Set the power switch to O (Off).
2. Attach the ethernet interface cable (customer supplied) to the ethernet port at the rear of the
printer.
3. Set the power switch to I (On). The printer will initiate its load routines and warm up. Wait
until you see the following message on the display:
"READY / ONLINE"
4. On the control panel, press the MENU button. The following message appears:
"MAIN MENU / CONFIGURATIONS"
5. Press the ◄ arrow until you see the following message:
"MAIN MENU / INTERFACE CFG"
6. Press the ▼ arrow. The display will show the following:
"INTERFACE CFG / Ethernet I/O"
Note: If the ethernet I/O is already selected skip steps 7 through 14 and resume at step 15.
7. Press SHIFT + ▼ simultaneously to Enable the ethernet interface. The display will show the
following:
"Ethernet I/O / Enable? NO yes"
8. Press the ◄ arrow until you see the following message:
"Ethernet I/O / Enable? no YES"
9. Press SHIFT + ▼ simultaneously to confirm your choice. The display will show:
"Ethernet I/O / Working..."
Then:
"Enable Ethernet / *RESTART PRINTER* "
10. Set the power switch to O (Off), wait 10 seconds, then set the power switch to 1 (On).
11. When the display reads "READY / ONLINE" press the MENU button:
"MAIN MENU / CONFIGURATIONS"
12. Press the ◄ arrow until you see the following message:
"MAIN MENU / INTERFACE CFG"
13. Press the ▼ arrow. The display will show the following:
"INTERFACE CFG / Ethernet I/O"
14. Press the ▼ arrow. The display will show the following:
"Ethernet I/O / DHCP Auto-Config"
15. Press the ◄ arrow. The display will show the following:
"Ethernet I/O / Config Network"
16. Press the ▼ arrow. The display will show the following:
"Config Network / IP Address"
38