Printronix L7032 User Manual page 133

3. Lift up the back-up exit rollers (the row of six white rollers) using the black handle on the side
of the rollers near
Note: For ph
paper gu
Chapter
4. Grasp the ends of the
Lift the exit roller pap
guide should click in
beneath the edge of t
5. Use the black handle
6. If the paper continues to jam after you have made
place, check whether the
Note: Consult the maintenance & service log t
For information about recommended re
about the maintenance & service log, see
7. If the fus er unit has r
Note: For instructio
6.3.2.2 Lead Edge of Pap
The lead edge of the paper is not in the fuser unit. (If i
Lead Edge of Paper Is in Fuser Drawer.)
1. At the pa per input sid
pull the paper back o
2. Remove th e OPC mod
paper. Clean up any
Note: For instru
Chapte
est the front of th e printer.
otog raphs showing how to lift
id e, see the instructions to r
4 , Maintenance.
paper guide, which covers
e r guide up and re
to place. The inside edge of t
he fuser unit.
to return the back-up exit r
fus er unit has reached th
eached the end of its life, r
ns on replacing the fuse
er Is in Area around Transfer Charger Unit
e of the printer, release th
ut of the p rinter.
ule and transfer charger u
debris or loose paper
ctions on removing the
r 4 , Maintenance.
up the back-up exit rollers a
ep lace the fuser unit and the exit
th e exit rollers (the row of six black rolle
turn it to i ts original position. T
h e exit roller paper guide sh
o llers to their original posi
sure that the exit rollers a
e end of its expected life.
o see when the fuser unit was r
placement intervals for the fuse
Chapter 4, Maint
epl ace it.
r u nit, see Chapter 4, Maint
t is, see the instructions in S
e t ractor locks, open the tracto
nit . Inspect the area for debri
that you find.
OPC m odule and transfer charger uni
nd the exit roller
rollers in
rs).
he exit roller paper
ould be just
tion.
re clicked into
eplaced.
r unit and
enance.
enance.
ection 6.3.2.1
r covers, and
s and loose
t, see
129