Printronix L7032 User Manual page 73

6. Close the metal door that covers the developer unit's trough.
7 . Pick up the developer unit by grasping its handle with your left hand and placing your right
hand underneath it.
8. Gently shake the developer unit from side to side to distribute the developer mix
the developer unit's trough.
4.10.3 Clean the Printer and Replace the Spent Developer Unit
Follow the instructions in Section 5.6 Monthly Cleaning Procedure. When you are done with
those instructions, return to this section.
Dispose of the spent developer unit in the trash.
4.10.4 Replace the Ozone Filter
1. Pull the spent ozone filter out of the back of the printer.
2. Dispose of the spent ozone filter in the trash.
3. Install the new ozone filter in the ozone filter opening on the back of the printer. Push it all
the way into the opening.
4.10.5 Initialize the Developer Unit
Caution: You must initialize the developer unit, or the printer will not apply toner properly.
If this happens, a service technician must remove the developer mix from the
developer unit and replace it with new mix. (Do not install a new toner cartridge
until after you have initialized the new developer unit.)
1. Press the MENU button. The LCD will display
MAIN MENU
CONFIGURATIONS
2. Press ◄ or ► until you see
MAIN MENU
CONSUMABLES on the display.
3. Press ▼ to select the CONSUMABLES menu.
4. Press ◄ or ► until you see
CONSUMABLES
INIT DEVELOPER on the display.
5. Press SHIFT + ▼ to select.
6. Use ◄ or ► to select No or Yes to continue, then use SHIFT + ▼ to begin initialization.
Initializing the developer takes about 190 seconds (a little more than three minutes) and
resets the Developer counter to zero.
7. When you see the "DEVELOPER INITIALIZED" message, press SHIFT + ▲ to exit the menu
system. "Off line" appears on the status display.
Record the replacement and initialization of the developer unit in the maintenance & service log.
evenly across
69