Printronix L7032 User Manual page 103

Figure 5-22. Returning the Exit Roller Paper Guide to Its Operating Position
3. Return the back-up exit rollers to their original position using the black handle on the side of
the rollers nearest the front of the printer.
4. Plug the fuser unit's two electrical connectors into the fuser drawer. Plug in the larger
connector and then plug in the smaller connector. Both of them will click into place.
5. Turn the fuser latch counterclockwise slightly and hold it while you start to push the fuser
drawer back into the printer. Once the fuser drawer starts to go into the printer, you can
release the fuser latch. Push the fuser drawer into the printer until it latches.
5.6.10 Install the Transfer Charger Unit
Push the transfer charger unit into the printer until it fits securely in place.
5.6.11 Install the Developer Unit
1. Pick up the developer unit by grasping its handle with your left hand and placing your right
hand underneath it.
2. As you move the developer unit into the printer, make sure that the semi-circular metal piece
on the lower right side of the developer unit fits over the black plastic guide, which is
connected to the latch. See Figure 5-23. To avoid catching the developer unit on the upper
part of the printer, you may need to angle the developer unit down slightly as you move it into
the printer.
99