Printronix L7032 User Manual page 43

17. Press the ▼ arrow. The display will show:
"IP Address / --0.--0.--0.--1"
18. To enter values: 1) Use ◄ and ► to move to the number you want to change; 2) Use ▲ and ▼
to select the desired number; 3) Press SHIFT + ▲ to go back up a level. Now press ► to go to
the next parameter. The display will show:
"Config Network / Subnet Mask"
19. Press the ▼ arrow. The display will show the following:
"Subnet Mask / --0.--0.--0.--1"
20. To enter values: 1) Use ◄ and ► to move to the number you want to change; 2) Use ▲ and ▼
to select the desired number; 3) Press SHIFT + ▲ to go back up a level. Now press ► to go to
the next parameter. The display will show:
"Config Network / Broadcast Adres"
Note: This address is automatically set by the system after you set the Subnet Mask above,
so you do not set this parameter.
21. Press ► to go to the next parameter. The display will show:
"Config Network / Gateway Address"
22. Press the ▼ arrow. The display will show the following:
"Gateway Address / --0.--0.--0.--1"
23. To enter values: 1) Use ◄ and ► to move to the number you want to change; 2) Use ▲ and ▼
to select the desired number; 3) Press SHIFT + ▲ to go back up a level. Now press ► to go to
the next parameter. The display will show:
"Config Network / Server IP Adres"
Note: You do not set this parameter. It is reserved for TFTP firmware upgrades.
24. Press ▲ to go back up a level.
25. Press the READY / STOP button twice to go to the READY / ONLINE state.
26. Now make and store a configuration printout that shows the ethernet addresses for this
printer. Press the MENU button:
"MAIN MENU / CONFIGURATIONS"
27. Press the ◄ arrow until you see the following message:
"MAIN MENU / TEST PRINT MENU"
28. Press the ▼ arrow. The display will show:
"TEST PRINT MENU / Configuration"
29. Press SHIFT + ▼ simultaneously to select the current printer configuration. The display will
quickly show:
"Configuration / Working..."
Then:
"Configuration / Ready to Print"
Then:
"TEST PRINT MENU / Configuration"
30. Press the READY / STOP button twice to print the configuration:
"Processing"
Then:
"Printing"
31. Verify that the network parameters are assigned correctly to the printer NIC (network
interface card) – shown on the configuration printout items under "Network Config." To verify
connectivity, at the DOS prompt type ping <IP Address>. Save the configuration printout
with the printer documentation.
39