Printronix L7032 User Manual page 47

2.4.3 Retraction Mode
Retraction Mode determines when the paper will move in relation to the cutting operation. You
select Retraction Mode using the Print Engine Configuration menu shown in section 2.2. The
operations of the retraction options vary, depending upon when the paper is cut manually or by
Auto Cut Mode. These actions are summarized in the tables below:
Retraction Mode
Retract @ End
Retract @ Start
No Retract
Retraction Mode
Retract @ End
Retract @ End
Retract @ Start
No Retract
2.4.4 Adjusting the Cutter
There are two adjustment knobs on the front of the cutter:
•
Turning both knobs clockwise move the cut position to the right; turning both knobs
counterclockwise moves the cut position to the left.
•
Turning either knob by itself moves the cut position on that side either right (turning the
knob clockwise) or left (turning the knob counterclockwise).
Adjust the position of the cut so that it is on the perforation of the paper. It is acceptable to cut
the paper just short of the perforation, but if the cut position is just past the perforation the
small strip of paper created may jam the printer or the cutter.
Print Job Sequence
Print → Retract Paper
Print
Retract Paper → Print
Note: Will not retract if paper
is already at TOF ("park")
position.
Print
Print Job Sequence
Print → Retract Paper
Print
Retract Paper → Print
Note: Will not retract if paper
is already at TOF ("park")
position.
Print
Manual Cut Process and Cut
Command
Feed → Cut → Retract (if press
FEED ◄ before job finishes
printing and retracting)
Cut → Retract (if press FEED
◄ after job finishes printing
and retracting)
Cut → Retract
Cut
Auto Cut Process
(Terminator, Host Cut Cmd)
Feed → Cut → Retract (if Cut
Wait Time ≥ 2.0 seconds)
Cut → Retract (if Cut Wait
Time < 2.0 seconds)
Immediately Cut → Retract
Immediately Cut
43