Printronix L7032 User Manual page 102

8. While the OPC module is out of the printer, clean any toner off the metal ledge, which is next
to the drum. See Figure 5-21.
Caution: Avoid touching the OPC drum, as touching it may contaminate the surface and
degrade the print quality.
Note: If you are replacing the OPC module, you do not to clean it. You will dispose of it in
the trash at the end of the procedure.
9. When you are done cleaning the metal ledge on the OPC module, cover the OPC module with
the opaque covering so no light reaches the OPC drum.
5 .6.8 Install the Waste Toner Bottle
P ush the waste toner bot
5.6.9 Install the Fuser Unit
1. Install the fuser unit by grasping its
and push the fuser unit back until i
2. Grasp the ends of the exit roller paper guide and return it to its operating position. See Figu
5-22. The exit roller pape
paper guide should be just beneath the edge of the fuser unit.
I mportant: If the exit rolle
fuser drawer and operate the printer. However, the paper will not feed pro
and you may get paper jam errors.
98
Figure 5-21. Cleaning the OPC Module
tle into the steel clips on the front of the printer.
two handles. Lower the fuser unit into the fuser drawer
t fits snugly against the back of the drawer.
r guide should click into place. The inside edge of the exit roller
r paper guide does not click into place, you will be able to close the
re
perly,