Printronix L7032 User Manual page 64

4.7.4 Replace the Waste Toner Bottle
1. With the printer's front access door open, remove the spent waste toner bottle. Grasp it from
both sides an d pull it forward. See Figure 4-7.
2. The spent toner bottle has a seal attached to the ou
the tape backing from the seal, and fold the seal over the opening in the top of the bottle. Pull
the seal tight across the opening and fasten the tape to the bottle.
3 . Dispose of the spent waste toner bottle in the trash.
4. Clean up any toner dust that you can see with the waste toner bottle removed.
5. Push the new waste toner bottle into the steel clips on the front of the printer. See Figure 4-8.
6. Record the replacement of th
service log.
7. If you have just opened a new toner kit and installed one of the two toner cartridges, go to
Section 4.7.5 Replace the Fuser Cleaning Roller below.
If you have just installed the remaining toner cartridge in an open toner kit, close the printer's
front access door. Put the printer on line and make it ready.
4.7.5 Replace the Fuser Cleaning Roller
The lifespan of a fuser cleaning roller is twice the lifespan of a toner cartridge. Every time that
you open a new toner kit and install the first new toner cartridge, install the new fuser cleaning
roller. When you install the second new toner cartridge, you do not need to install a new fuser
cleaning roller.
60
Figure 4-8. Installing the New Waste Toner Bottle
e toner cartridge and waste toner b
tside of the bottle. See Figure 4-7. Remove
ottle in the maintenance &