Maintenance; Resetting; D Partial Reset - Icom ID-4100A Basic Manual

9

MAINTENANCE

■ Resetting

Occasionally, erroneous information will be displayed when,
for example, first applying power. This may be caused
externally by static electricity or by other factors. If this
problem occurs, turn OFF the transceiver. After waiting a
few seconds, turn ON the transceiver again. If the problem
is still there, perform a Partial reset or an All reset.
A Partial reset resets the operating settings to their default
values (VFO frequency, VFO settings, menu contents)
without clearing data as listed below:
Memory channel contents
Call channel contents
Message data
GPS Memory contents
BE CAREFUL! An All reset clears all programming and
returns all settings to their factory defaults. After All
Resetting, you cannot use the DR function because the
Repeater List contents are also cleared.
See the Advanced manual for details. (Section 10)
53
BASIC MANUAL
Scan Edge contents
Call sign memories
DTMF memory contents
Repeater list

D Partial Reset

Others > Reset > Partial Reset
1. Push [MENU].
2. Rotate [DIAL] to select "Others," then push [ï].
• Displays the OTHERS screen.
3. Select "Reset," then push [ï].
• Displays the RESET screen.
4. Select "Partial Reset," then push [ï].
• The confirmation dialog "Partial Reset?" is displayed.
5. Select <YES>, then push [ï].
• When the partial reset is completed, "PARTIAL RESET" is
displayed, then the display automatically returns to the default
screen.