I Scan Edges Programming - Icom IC-2820H Instruction Manual

I Scan edges programming

Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 1A/1B to 9A/9B, in memory channels.
q Set the edge frequency of the desired frequency range in
VFO mode:
➥ Set the frequency using the desired band's [DIAL].
➥ Set other data (e.g. repeater settings, etc.) if desired.
w Push the same band's [M/CALL•MW] for 1 sec.
• "X" indicator and channel number blink.
e Rotate the [DIAL] to select one of scan edge channel, 1A
to 9A.
[EXAMPLE]: Programming 145.300 MHz into scan edges 1A.
V/MHz
Push to select VFO mode.
SCAN
Rotate
Rotate for setting frequency, etc.
M/CALL
Push (Left band's) for 1 sec. and continue to push
MW
"
"
Beep
"
Beep
" Beep
"
r Push the [M/CALL•MW] for 1 sec. to program.
• 3 beeps sound and VFO is automatically selected.
• Scan edge 1B to 9B is automatically selected when continuing to
push the [M/CALL•MW] after programming.
t To program a frequency for the other pair of scan edges,
1B to 9B, repeat steps q and r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
M/CALL
Push for 1 sec.
MW
"
"
Beep
"
"
Beep
"
"
Beep
SCAN OPERATION
➠
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
52