SECTION 4
Functions
Noise Monitor Function
When executing commands for Tag communications, the maximum value of the noise level can be
attached to the response data to constantly monitor noise conditions.
The noise monitor function cannot be used when the V680-H01 Antenna is connected.
To use the noise monitor function it must be enabled using the PARAMETER SET (SP) command.
Response Examples
● Noise Monitor Function Enabled
RD 00 1 0 .. . .. . [01] * CR
● Noise Monitor Function Disabled
RD 00 1 0 . .. .. . * CR
RFID System
96
User's Manual
p. 147
Maximum noise level ("01" to "99")
Read data
Resend Flag (Always "0".)
Antenna channel ("1": channel 1, "2": channel 2)
End code
Read data
Resend Flag (Always "0".)
Antenna channel ("1": channel 1, "2": channel 2)
End code