Omron V680-CA5D01-V2 User Manual page 208

AUTO COPY (AP)
When the ID Controller receives the AUTO COPY command, it waits for Tags to approach and then
reads data from the memory of the Tag using one Antenna and writes it to the memory of the Tag in the
other Antenna's communications area. An error response (end code 76: copy error) will be returned if
there is no Tag at the copy destination.
This command cannot be used with the V680-CA5D01-V2.
1:1 Protocol
Command
Antenna
designation
Data
desig- Read area start
Command
address
code nation
× × ×
A P H 1/2
2 1 1 4
Data designation
Antenna designation
Read area start address
No. of bytes to copy
Destination start address
Response
Command
End code
code Terminator
*
A P 0 0 CR
2 2 2
End code
Destination start
No. of bytes to copy
address
× ×
× × × × ×
4
Always "H".
Specifies the Antenna with which to communicate.
"1": Reads from Antenna 1 and writes to Antenna 2.
"2": Reads from Antenna 2 and writes to Antenna 1.
Specifies the start address of the area in the Tag from which data is to be read from in 4-digit
hexadecimal.
Setting range: 0000 to FFFF
H H
Specifies the number of bytes of data to copy in 4-digit hexadecimal.
Setting range: 0001 to 0800
H H
Specifies the start address of the area in the Tag to which data is to be written in 4-digit
hexadecimal.
Setting range: 0000 to FFFF
H H
Indicates the execution result for the command.
"00" indicates a normal end.
Refer to List of End Codes for information on other end codes.
p. 235
Terminator
× *
×
CR
4 2
SECTION 5
Communications
RFID System
205
User's Manual