Omron V680-CA5D01-V2 User Manual page 152

1:N Protocol
Command
Controller No.
Fixed
Command Process
value
SOH code code
×
×
@ 0 S P
(Upper
digit)
2
1 1 2
Process code
(Upper digit)
Process code
(Lower digit)
Parameter data
(when there are changes)
Note 1: Parameters 1, 2, 9, and H are valid only when internal settings are enabled (i.e., when pin 1 on SW3 is ON).
Note 2: The data number of the parameter data is the number specified for the lower digit of the process code.
The settable values for the data number are the same as for the parameter specified by the lower digit of the process
code.
Parameter data
(when there are changes)
FCS
×
×
× ×
× × ×
(Lower
digit)
2 0 to 4 2
Specifies the process to perform for the parameter.
"0": Change internal setting.
"1": Read internal setting.
"9": Return initial setting to default value.
Specifies the parameter.
"1": Controller No. (See note 1.)
"2": Write verification enable (See note 1.)
"3": Reception sensitivity
"9": Tag communications procedure (See note 1.)
"C": Error output time
"D": Number of test bytes setting
"E": Tag history noise detection enable (Noise monitor function setting)
"F": Output contact mode setting
"G": Noise detection count setting
"H": Write protection setting (See note 1.)
Data No. (See note 2.)
"1" Specify 2 decimal digits. "00" to "31" (unit number)
Default value: "00"
"2" "0": Without verification
"1"With verification (default value)
"3" "0": Weak
"1": Standard
"9" "00": 1:1 protocol (default value)
"01": 1:N protocol
"C" Specify 4 decimal digits. "0000" to "9999" (ms)
"0000": Infinite, Default value: "0500" (ms)
"D" Specify 4 hexadecimal digits. "0001" to "0800" (bytes)
Default value: "0001" (bytes)
"E" "00": No noise detection for communications history (default value)
Noise monitor function disabled.
"01": Noise detection for communications history
Noise monitor function enabled.
"F" "00": Two Output Mode
BUSY, ERROR, OUT1, and OUT2 (default value)
"01": Four Output Mode
OUT1, OUT2, OUT3, and OUT4
"G" Specify 4 decimal digits. "0001" to "0100" (times)
Default value: "0010" (times)
"H" "00": Write protection OFF
"01": Write protection ON (default value)
Terminator
× *
CR
2
Settable values
SECTION 5
Communications
RFID System
149
User's Manual