AUTO DATA FILL (AF)
The AUTO DATA FILL command writes the specified data to the specified number of bytes beginning
from the specified start address when the Tag approaches. A response will be returned when commu-
nications with the Tag have been completed.
1:1 Protocol
Command
Antenna
designation
Data
Write area start
desig-
Command
address
nation
code
×
×
A
F
A/H
1/2
2
1
1
4
Data designation
Antenna designation
Write area start address
No. of bytes to write
Designated data
Response
Command
Terminator
code
End code
*
A
F
0
0
CR
2
2
2
End code
No. of bytes
Designated data
to write
×
×
×
×
×
×
×
2
2 or 4
Specifies the code format when sending the read data response.
"A": ASCII
"H": Hexadecimal
Specifies the Antenna with which to communicate.
"1": Antenna 1
"2": Antenna 2
Specifies the start address of the area in the Tag to which data is to be written in 4-digit
hexadecimal.
Setting range: 0000
to FFFF
H
H
When specifying in odd bytes, this writes the 1 digit prior to the designated data for ASCII code
specification, or the 2 digits of the designated data for hexadecimal specification, to the last 1 byte
of data in the Tag.
Specifiable range: 01
to FF
, 00
H
H
Specified the data to be written to the Tag.
• ASCII: 2 digits specified.
• Hexadecimal: 4 digits specified.
Indicates the execution result for the command.
"00" indicates a normal end.
Refer to List of End Codes for information on other end codes.
p. 235
Terminator
*
×
CR
2
(The maximum of 256 bytes will be written if 00
H
SECTION 5
Communications
is specified.)
H
RFID System
201
User's Manual