Omron V680-CA5D01-V2 User Manual page 64

DIP Switch Settings
SW3, Pin 1 (SW Enable Switch)
SW3, pin 1
OFF DIP switch enabled
ON Internal settings enabled
Note: SW1, SW2, SW3 (pins 3 to 9), and SW4 (pins 5 to 7) are enabled only when the DIP switches
are enabled.
When the internal settings are enabled, the values specified by the TR and SP commands are valid.
The default values will be enabled if values have not been specified using the TR and SP commands.
p. 228, p. 230
SW3, Pin 2 (Reserved by System)
Do not use this pin. Always set this pin to OFF.
SW3, Pins 3 and 4 (Baud Rate)
SW3, pin 3 SW3, pin 4
OFF 9,600 bps
OFF
ON 19,200 bps
OFF 38,400 bps
ON
ON 115,200 bps
SW3, Pin 5 (Data Length)
SW3, pin 5
OFF 7 bits
ON 8 bits
SW3, Pins 6 and 7 (Parity)
SW3, pin 6 SW3, pin 7
OFF Even
OFF
ON None
OFF Odd
ON
ON Even
SW3, Pin 8 (Stop Bit Length)
SW3, pin 8
OFF 2 bits
ON 1 bit
SW3, Pin 9 (Communications Protocol)
SW3, pin 9
OFF 1:1
ON 1:N
(SW3, SW4)
Preparations for Communications
Description
Description
Description
Description
Description
Description
SECTION 3
RFID System
61
User's Manual