Installation - Omron V680-CA5D01-V2 User Manual

SECTION 2
Installation, Connections, and Wiring

Installation

To increase the reliability of the V680-CA5D01-V2 / -CA5D02-V2 ID Controllers and ensure full functionality,
install the ID Controller according to the instructions provided in this section.
Installation Site
Do not install the ID Controller in the following locations.
• Locations exposed to ambient temperatures that are not between − 10 and 55 ° C or where there are
radical temperature changes resulting in condensation
• Locations exposed to humidity that is not between 25% and 85%
• Locations subject to corrosive gas, flammable gas, dust, salt, or metal powder
• Locations that will expose the ID Controller to direct vibration or shock
• Locations exposed to direct sunlight
• Locations exposed to spray of water, oil, or chemicals
• Locations more than 2,000 m above sea level
Mounting in a Panel
The ID Controller can be used at an ambient temperature range of − 10 to 55 ° C. Be sure to observe the
following precautions.
• Make sure that the ID Controller is provided with sufficient ventilation space.
• Do not install the ID Controller close to heaters, transformers, or large-capacity resistors that radiate
excessive heat.
Installation Method
Mounting Directly in a Panel
Be sure to secure the ID Controller with two M4 screws together with spring washers and flat washers
when enclosing the ID Controller in a panel.
Recommended tightening torque: 1.2 N·m
RFID System
28
User's Manual
80 90
95
10
Two, M4
80