Omron V680-CA5D01-V2 User Manual page 39

SECTION 2
Installation, Connections, and Wiring
Assembling and Connecting the Communications Connector
Have a connection cable and connector ready.
Controller end
OMRON
XM3B-0922-111
Plug
Assembling the Connector
1.
Prepare the end of the cable as shown below.
40
5
Conductors
Braided shield
Shield tape
2.
Solder the conductors to the plug pins.
Plug Jumper
3.
Attach housing A2 of the Hood to the Plug and secure the aluminum-taped portion with the cable
clamp.
4.
Secure the two connector lock screws and put on housing B2 to complete the connector.
RFID System
36
User's Manual
OMRON
XM2S-0911
Hood
OMRON
XM2A-0901
Plug
35
Cable bushing
10±1
12
Cable bushing
Aluminum
tape
Two, M2.6 lock screws
Housing A2
Cable clamp
Host device end
• Insert the cable into the cable bushing.
• Unravel the braided shield for approximately 10 mm and fold it
back on the cable bushing.
• Apply shield tape to the folded braided shield.
Pin No. Symbol Signal name
9 SG Signal ground
2 SD Send data
3 RD Receive data
4 (See note.) RS Request to send
5 (See note.) CS Clear to send
Note: Short-circuit pins 4 (RS) and 5 (CS) with a jumper.
Housing B2