Omron V680-CA5D01-V2 User Manual page 130

WRITE REPEAT (RP)
The WRITE REPEAT command is used to execute the most recently executed write command again.
1:1 Protocol
Command
Command
code Terminator
*
R P C R
2
2
Response
Antenna
Resend flag
Command
desig-
code
End code
nation
× × × ×
0 0 0
2 2 1 1
Note: When using the multi-access trigger communications designation (MT) for a previously exe-
cuted write command, the ID controller returns an end code of 03 after communicating with all
Tags.
Command code
UID
Write command information is cleared at the following time.
• When the ID Controller's power supply is reset.
If a WRITE REPEAT command is executed after write command information has been cleared, a command input error
will occur.
1:N Protocol
Command
Command
Controller No.
code
×
× ×
@ 0 R P
1 1 2 2
Response
Command
Controller No.
End code
code
× × × ×
0
@ 0
2
1 1 2
Note: When using the multi-access trigger communications designation (MT) for a previously
executed write command, the ID controller returns an end code of 03 after communicating with
all Tags.
Command code
UID
Write command information is cleared at the following time.
• When the ID Controller's power supply is reset.
If a WRITE REPEAT command is executed after write command information has been cleared, a command input error
will occur.
Terminator
UID
...
× × × *
CR
0 or 16 2
The command code is the same as the last write command that was executed.
A unique identifier used to identify Tags.
Added only for multi-access communications designations (MT/MR) for a previously executed
write command.
Terminator
FCS
× *
CR
2 2
Antenna
Resend flag
desig-
nation UID
...
× × × ×
0
0
2 1 1
0 or 16
The command code is the same as the last write command that was executed.
A unique identifier used to identify Tags.
Added only for multi-access communications designations (MT/MR) for a previously executed
write command.
FCS Terminator
*
× × ×
CR
2 2
SECTION 5
Communications
RFID System
127
User's Manual