Omron V680-CA5D01-V2 User Manual page 117

SECTION 5
Communications
Controller Control Commands
The controller control commands are used to set communication parameters or when resending the
response.
Command
code
US
TR
SP
MO
SE
RR
CC
CF
HI
Host Commands
The following commands are used to control the ID Controller.
Command
code
TS
VS
Evaluation Command
The following command is used to check ambient noise.
Command
code
NS
RFID System
114
User's Manual
Name
UID ADDITION SET
COMMUNICATIONS SET
PARAMETER SET
OPERATION MODE CHANGE
OPERATION CONDITION SET
RESPONSE RESEND
CONTROLLER CONTROL
READ ERROR INFORMATION
READ HISTORY INFORMATION Reads the ID Controller's history information.
Name
TEST
VERSION READ
Name
NOISE DETECTION
Description
Sets whether or not UID should be added to the read command (RD)
response.
Sets serial communications parameters for communicating with the
host device.
Sets, reads, or initializes ID Controller parameters.
Changes the operation mode.
Sets operation conditions for Self Execution Mode.
Resends the last response that was sent.
Controls or confirms ID Controller I/O.
Reads the error log.
Description
Checks the communications conditions between the ID Controller and
host device. The data sent by the host device is returned by the ID
Controller without modification.
Read the software version of the ID Controller.
Description
Measures noise under normal conditions. The ID Controller returns
the noise level as the results of the measurement.
Page
p. 144
p. 145
p. 147
p. 151
p. 153
p. 159
p. 160
p. 162
p. 164
Page
p. 166
p. 167
Page
p. 168