Omron V680-CA5D01-V2 User Manual page 171

SECTION 5
Communications
Evaluation Command
NOISE DETECTION (NS)
The NOISE DETECTION command is used to check the noise level when the command is received.
This Command cannot be used when the V680-H01 Antenna is connected.
1:1 Protocol
Command
Command Fixed
code
value
N S 0
2 1
Fixed value
Antenna designation
Response
Command
End code
code
×
N S
2
Average noise level
Maximum noise level
Minimum noise level
RFID System
168
User's Manual
Antenna
designation
Terminator
*
1/2 CR
1 2
Always "0".
Specifies the Antenna with which to communicate.
"1": Antenna 1
"2": Antenna 2
Resend flag
Antenna
desig- Average Maximum
nation noise level noise level
× × × × ×
1/2 0
2 1 1 2 2
Gives the average noise level that was measured.
"00" to "99"
Gives the maximum noise level that was measured.
"00" to "99"
Gives the minimum noise level that was measured.
"00" to "99"
Minimum
noise level
Terminator
× × *
CR
2 2