Omron V680-CA5D01-V2 User Manual page 206

Copy (CP)
The COPY command reads data from the memory of the Tag in one Antenna's communications area
and writes it to the memory of the Tag in the other Antenna's communications area. If there is no Tag to
copy data from, the ID Controller will return an error response with an error code of 72 (Tag missing
error). If there is no Tag to write to, the ID Controller will return an error response with an error code of
76 (copy error).
This command cannot be used with the V680-CA5D01-V2.
1:1 Protocol
Command
Antenna
designation
Data
Read area start
Command desig-
code nation address
×
×
×
C P H 1/2
2 1 1 4
Data designation
Antenna designation
Read area start address
No. of bytes to copy
Destination start address
Response
Command
End code Terminator
code
*
C P 0 0 CR
2 2 2
End code
Destination start
No. of bytes to copy address
× × ×
× × ×
×
4
Always "H".
Specifies the Antenna with which to communicate.
"1": Reads from Antenna 1 and writes to Antenna 2.
"2": Reads from Antenna 2 and writes to Antenna 1.
Specifies the start address of the area in the Tag from which data is to be read from in 4-digit
hexadecimal.
Setting range: 0000 to FFFF
H H
Specifies the number of bytes of data to copy in 4-digit hexadecimal.
Setting range: 0001 to 0800
H H
Specifies the start address of the area in the Tag to which data is to be written in 4-digit
hexadecimal.
Setting range: 0000 to FFFF
H H
Indicates the execution result for the command.
"00" indicates a normal end.
Refer to List of End Codes for information on other end codes.
p. 235
Terminator
× ×
*
CR
4 2
SECTION 5
Communications
RFID System
203
User's Manual