Omron V680-CA5D01-V2 User Manual page 68

Self-execution Mode
The operation conditions must be registered in Command Execution Mode using the OPERATION CONDITION SET
(SE) command.
p. 153
Self-completion operation can be performed so that communications with Tags are automatically exe-
cuted according to the operation conditions registered in the ID Controller, the results of communica-
tions with the Tags are judged (judgment conditions), and the results are output to the four external
outputs (OUT1, OUT2, OUT3, and OUT4) or the RS-232C port. A very simple system can be built
because the ID Controller does not need to be controlled from the host device.
The following operation conditions can be registered.
Item
Execution processing Only Tag communications commands can be used.
The only RA and RI communications modes can be used.
Judgment conditions One of the following can be set for each output.
1) Output judgment of Tag communications results.
2) Output results of comparing response data to set data.
Result output The following five outputs can be set for when judgement conditions have been met. (See note.)
Judgement conditions can be set for each output.
1) Output to OUT1. The output time can be set.
2) Output to OUT2. The output time can be set.
3) Output to OUT3. The output time can be set.
4) Output to OUT4. The output time can be set.
5) Return the response to the host computer.
Note: There are 2 external outputs (OUT1 and OUT2) if the I/O arrangement is set to the same I/O arrangement as the
V600(V680-CA5D@@-V2).
Self-execution Mode will not work if the V600 command system is set. For the V680 command system, either 2 outputs
(default setting of 0) or 4 outputs can be switched. Refer to PARAMETER SET (SP) for details.
p. 147
The operation conditions are stored in the ID Controller's internal non-volatile memory and do not need to be set again
each time the power is turned ON.
Preparations for Communications
Settings
SECTION 3
RFID System
65
User's Manual