Omron V680-CA5D01-V2 User Manual page 156

OPERATION CONDITION SET (SE)
The OPERATION CONDITION SET command is used to set operation conditions for the Self Execu-
tion Mode. Always set the operation conditions in the following order from 1 to 5.
1. Clear the Operation Conditions
Command
Command Process
code code Terminator
*
2 0 CR
S E
2 2 2
Process code
Response
Command Fixed Resend
code End code value flag Terminator
× × *
S E 0 0
2 2 1 1
2. Set the Execution Command
Command
Operation
Command Process condition
code code parameter
× × ×
0 0
S E
2 2 2
Process code
Operation condition
parameter
Execution command string Specifies the command to be executed, with the following restrictions.
Response
Command Fixed Resend
code End code value flag Terminator
× ×
S E 0 0
2
2 1 1
Always "20".
CR
2
Execution Command Terminator
× ... × ×
*
CR
n 2
Always "00".
"C1": Sets an execution command for channel 1.
"C2": Sets an execution command for channel 2.
Note: "C2" will result in an error (15) if specified for a One-channel Controller (V680-CA5D01-V2).
Also, if execution commands are not set for both channels 1 and 2 for a Two-channel Controller
(V680-CA5D02-V2), the output conditions cannot be set.
1. Only Tag communications commands can be set: RD, WT, DF, or MD.
2. The communications designation must be RA or RI.
3. A maximum of 256 bytes can be written (for either ASCII or hexadecimal data)
The execution command will be set to "XX" if the execution command string is omitted.
*
CR
2
SECTION 5
Communications
RFID System
153
User's Manual