Omron V680-CA5D01-V2 User Manual page 154

OPERATION MODE CHANGE (MO)
The OPERATION MODE CHANGE command is used to change the mode of the ID Controller.
1:1 Protocol
Command
Execution
designation
Process
desig-
Command
Terminator
nation
code
× × *
CR
M O
2 1 1 2
Process designation
Execution designation
Before changing the operation mode to Self Execution Mode, use the OPERATION CONDITION SET command to set
the operation conditions. If the OPERATION MODE CHANGE command is executed with the process designation set to
"S" when the operation conditions have not been set, an execution status error (end code 15) will occur.
p. 153
If the OPERATION MODE CHANGE command is executed in Host Communications Monitor Mode with the process
designation set to "S," an execution status error (end code 15) will occur. To change from Host Communications Monitor
Mode to Self Execution Mode, first change to Command Execution Mode.
Response
Resend flag
Fixed
Command
End code
code value
Terminator
M O 0 0 0 0
2 2 1 1
1:N Protocol
Command
Process
desig-
Command
Controller No. nation
code
×
×
M O
@ 0
2 2
1 1
Process designation
Execution designation
Before changing the operation mode to Self Execution Mode, use the OPERATION CONDITION SET command to set
the operation conditions. If the OPERATION MODE CHANGE command is executed with the process designation set to
"S" when the operation conditions have not been set, an execution status error (end code 15) will occur.
p. 153
If the OPERATION MODE CHANGE command is executed in Host Communications Monitor Mode with the process
designation set to "S," an execution status error (end code 15) will occur. To change from Host Communications Monitor
Mode to Self Execution Mode, first change to Command Execution Mode.
Specifies the operation mode of the ID Controller.
S: Self Execution Mode
C: Command Execution Mode
P: Host Communications Monitor Mode
Always "0".
*
CR
2
Execution
designation
FCS Terminator
× × × × *
CR
1 1 2 2
Specifies the operation mode of the ID Controller.
S: Self Execution Mode
C: Command Execution Mode
P: Host Communications Monitor Mode
Always "0".
SECTION 5
Communications
RFID System
151
User's Manual