Omron V680-CA5D01-V2 User Manual page 225

SECTION 5
Communications
ABORT (XZ)
The ABORT command can be used to reset the ID Controller to command standby status during com-
munications with the host device or a Tag if any sort of trouble occurs, e.g., if the ID Controller does not
return a response. The ID Controller does not return a response to the ABORT command.
1:1 Protocol
Command
Command
Terminator
code
*
X Z
2 2
About 100 ms is required after the ID Controller receives the ABORT command before it can receive the next command.
1:N Protocol
Command
Command
Controller No.
code
× ×
@
3
About 100 ms is required after the ID Controller receives the ABORT command before it can receive the next command.
RFID System
222
User's Manual
CR
Terminator
FCS
× *
×
X Z CR
2
2 2