Omron V680-CA5D01-V2 User Manual page 224

Communications Subcommands
Communications subcommands are used in combination with commands for Tag communications.
They cannot be used by themselves to communicate with a Tag.
COMMAND PROCESSING TERMINATE (AA)
The COMMAND PROCESSING TERMINATE command cancels any command except for polling
commands and returns the ID Control to command standby status. This command can also be used to
cancel communications for expansion commands with divided frames before completion of the expan-
sion command.
1:1 Protocol
Command
Command
Terminator
code
* CR
A A
2 2
Response
Command
Terminator
End code
code
×
× *
CR
A A
2 2 2
End code
1:N Protocol
Command
Command
Controller No. FCS
code
× × × ×
@ A A
3 2 2
Response
Command
Controller No. End code
code
× ×
× ×
@ A A
3 2 2
End code
Indicates the execution result for the command.
14: No automatic or normal commands being processed.
75: Processing terminated before a Tag was detected.
76: Processing terminated while reading from or writing to a Tag.
Refer to List of End Codes for information on other end codes.
p. 235
Terminator
*
CR
2
FCS
Terminator
× × *
CR
2 2
Indicates the execution result for the command.
14: No automatic or normal commands being processed.
75: Processing terminated before a Tag was detected.
76: Processing terminated while reading from or writing to a Tag.
Refer to List of End Codes for information on other end codes.
p. 235
SECTION 5
Communications
RFID System
221
User's Manual