Omron CX-PROCESS TOOL V5.2 - REV 10-2010 Operation Manual page 271

Initial Settings for Online Connections
Starting Up
Communications Service
Automatically Setting Addresses
1, 2, 3...
If Ethernet is used, it is necessary to start up the FinsGateway communications
service manually. Select FinsGateway Settings from the FinsGateway Menu.
In addition to manually setting the network, node, and unit addresses, they can
also be set automatically by searching for Loop Control Units connected to net-
works of the PLC connected to the CX-Process Tool.
Use the following procedure to automatically set the addresses.
1. Select the LCU element and then select Find LCU from the File Menu.
Section 4-2
245