Table of Contents
Advertisement
8/11/22, 10:07 AM
Install Material Bottles
1. For the purpose of the
bottles of
part
2. Unpack the
sleeves and material carton to store partially used material bottles.
3. Press and release the upper left
support material
the top of the material bottle until you hear a click to make certain the bottles are fully seated.
4. Press and release the upper right
part material into the MDM. Pull
top of the material bottle until you hear a click to make certain the bottles are fully seated.
5. As previously stated, only
build jobs will require all MDMs to be fully loaded with both support and part material.
Install Build Platform
1.
Clean
the platform using
2.
Open
the chamber door.
infocenter.3dsystems.com/projetmjp5500x/print/book/export/html/966
Demo
print, we will use only two bottles of
material. Make certain that the two bottles of part material are the same type.
material bottles
and the Global Health and Safety (GHS) Sheet from cartons. Save
material delivery module
into the MDM. Pull levers up and place bottle down into the holder. Press on
material delivery module
levers
two MDM
isopropyl alcohol
Quick Start Guide
to open it. Install two bottles of
up and place bottle down into the holder. Press on the
are loaded with material for the
before installing the
support material
to open it. Install two bottles of
Demo
print. Subsequent
platform
into the printer.
and two
6/13
Advertisement
Table of Contents
