Installation Of Print Platform Without Offload Cart - 3D Systems ProX 800 User Manual

INSTALLATION OF PRINT PLATFORM WITHOUT OFFLOAD CART

Verify that the MDM is installed in the printer before starting this process. Wear nitrile gloves when handling the print pad to
prevent material exposure to your skin.
1. Verify that the elevator is at its offload position. If necessary, move it to its offload position by selecting
the Move to Offload button on the
NOTE: If this is right after a build, you may get the warning message, "Print applicator is not
at home position ." If so, press
2. Place the print pad between the
3. Pull the print pad forward against the
4. Make sure that the front edge of the print pad engages with the notched print pad guides.
5. Move the elevator to the Start position by pressing
NOTE: While starting a print job will automatically move the build platform home, it is best
to manually home the elevator after installing to prevent bubbles and other defects in the
vat resin .
1
2
Front print pad notched guides
3D Systems, Inc.
Elevator/Leveler screen under the
Print Applicator > Move to Home .
L-shaped guides (1) towards the rear of the print chamber.
print pad notched guides
Move to Start
L-Shaped Guides
Tools menu.
at the front (2).
on the Elevator/Leveler
Print Pad
Print Pad inside Print Chamber
(MDM not shown for clarity, but should be installed)
60
screen under the Tools menu.
Elevator
Platform