Working From The Setup Tab - Ametek 5830 User Manual

Working From the Setup Tab

Use the Setup tab to define analyzer parameters.
Figure 3-10.
Schedule tab.
Gas
Units
Gas Saver check box
4–20 mA Output
PN 583054901, Rev YA
Select the gas being sampled.
Dewpoint Temp – If you select dewpoint temp, the Process Pressure
box is activated and you must enter a process pressure parameter in
kPa.
Select the unit of measurement.
Check this box to enable Gas Saver. This feature allows you to minimize gas
consumption.
Set up your Analog Output range.
20 mA
Enter your high Analog Output limit.
4 mA
Enter your low Analog Output limit.
Hold during zero
Check this box to hold analyzer output during Verification and Zero.
|
Controller/Interface 3-21