Table of Contents
Advertisement
Working From the Setup Tab
Use the Setup tab to define analyzer parameters.
Figure 3-10.
Schedule tab.
Gas
Units
Process pressure
4–20 mA Output
PN 305804902, Rev A
Select the gas being sampled.
Dewpoint Temp – If you select dewpoint temp, the Process Pressure
box is activated and you must enter a process pressure parameter in
kPa.
Select the unit of measurement.
Enter the process pressure in kPa.
Set up your analog output range.
20 mA
Enter your high analog output limit.
4 mA
Enter your low analog output limit.
Hold during zero
Check this box to hold analyzer output during Verification and Zero.
|
Controller/Interface
3-19
Advertisement
Table of Contents
