Programmable Timing Pattern Controller; Overview; Features - Hitachi F-ZTAT H8/3039 Series Hardware Manual

Section 9 Programmable Timing Pattern Controller

9.1 Overview

The H8/3039 Series has a built-in programmable timing pattern controller (TPC) * that provides
pulse outputs by using the 16-bit integrated timer-pulse unit (ITU) as a time base. The TPC pulse
outputs are divided into 4-bit groups (group 3 to group 0) that can operate simultaneously and
independently.

9.1.1 Features

TPC features are listed below.
• 15-bit output data
• Maximum 15-bit data can be output. TPC output can be enabled on a bit-by-bit basis.
• Four output groups and one 3-bit output.
• Output trigger signals can be selected in 4-bit groups to provide up to three different 4-bit
outputs and one 3-bit output.
• Selectable output trigger signals
• Output trigger signals can be selected for each group from the compare-match signals of four
ITU channels.
• Non-overlap mode
• A non-overlap margin can be provided between pulse outputs.
Note: Note that since this LSI does not have a TP
pattern controller (TPC).
pin, it is a 15-bit programmable timing
14
285