YASKAWA Z1000U Technical Manual page 67

u
Drive Cover Removal
Follow the procedures below to remove and reattach the drive covers for wiring.
u
Drives in Bypass Models D024 to D114 and B011 and B124
n Removing the Terminal Cover
1.
Loosen the terminal cover screw.
2.
Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal cover.
n
Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided.
61 and Wiring the Drive Control Circuit Terminal
Reattach the terminal cover after completing the wiring to the drive and other devices.
YASKAWA SIEP YAIZ1D 01C Z1000U HVAC MATRIX Drive Bypass Technical Manual
Figure 3.21 Removing the Terminal Cover
Figure 3.22 Removing the Terminal Cover
on page
<1>
Figure 3.23 Reattaching the Terminal Cover
Refer to Wiring the Main Input Circuit on page
70 for details on wiring.
3.5 Control Circuit Wiring
3
67