Removing And Replacing The Serial Port Cable - HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual

Results Results
To replace the component, reverse the removal procedure.

Removing and replacing the serial port cable

Removing and replacing the serial port cable
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a hex screwdriver available.
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 113