HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual page 58

2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the front bezel .
6. Remove all drives .
7. Remove the access panel .
8. Disconnect the drive power and onboard SATA cables from the drive backplane.
9. Remove the 8 SFF drive cage.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 58