HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual page 102

Subtopics Subtopics
Removing and replacing the boot device Removing and replacing the boot device
Removing and replacing a boot device drive Removing and replacing a boot device drive
Relocating the M.2 drive retaining latches Relocating the M.2 drive retaining latches
Removing and replacing the boot device Removing and replacing the
About this task About this task
CAUTION: CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all PCIe slots have either an expansion
slot cover or an expansion card installed.
CAUTION: CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
Procedure Procedure
1. Back up all server data.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
boot device
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 102