HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual page 97

c. Carefully lift the port end of the module up (callout 2), and then disconnect the module from the system board (callout 3)
Results Results
To replace the component, reverse the removal procedure.
M.2 SATA SSD replacement M.2 SATA SSD replacement
Subtopics Subtopics
Removing and replacing the M.2 SATA SSD add‑in card Removing and replacing the M.2 SATA SSD add
Removing and replacing the M.2 SATA SSD on the add‑in card Removing and replacing the M.2 SATA SSD on the add
Removing and replacing the M.2 SATA SSD add‑in card Removing and replacing the M.2 SATA SSD add
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
About this task About this task
in card
in card
in card
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 97