HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual page 60

CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
Procedure Procedure
1. Remove the power supply blank from the bay.
2. Immediately install the replacement power supply blank spare.
Removing and replacing the media bay blank Removing and replacing the media bay blank
About this task About this task
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the front bezel .
5. Press and hold the latch (callout 1), and then pull out the blank from the bay (callout 2).
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 60