HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual page 95

Removing and replacing the iLO-M.2-serial module Removing and replacing the iLO-M.2-serial module
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Phillips No. 1 screwdriver
4.5 mm hex nut screwdriver
About this task About this task
CAUTION: CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
CAUTION: CAUTION:
The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the server
when a port blank is removed without the corresponding I/O port option installed.
Procedure Procedure
1. If the M.2 SSD is installed, back up all server data on the M.2 SATA SSD .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 95